User's Manual

Page 11 of 13
Press “CANCEL” to at any time or after the final “SET/OK” to exit the menu.
Self Test
:
Press the “SELF TEST” key on the remote to instruct the radar to perform a self test. The
radar will display “OK” after about 6 seconds if the test passes. It will then reset and
count up from 1 to 9 and then the display will blank out.
Display Units (MPH or KMPH)
:
1. Press the “F1” key on the remote
[The radar will display “F1”]
2. Press the “4” key
[The radar will display the current value code. 0 = MPH, 1 = KMPH]
3. Press 0 to display speed in MPH or 1 to display speed in KMPH
4. Press “SET/OK” key to save in memory.
[Radar will restart and count up from 1 to 9 and the display will go blank. The
unit is now ready]
Reset Factor Settings:
1. Press the “F1” key on the remote
[The radar will display “F1”]
2. Press the “3” key on the remote
3. Press the “SET/OK”
[Radar will display “OK” and then restart and count up from 1 to 10 and the
display will go blank. This will reset the baud rate to 115200, display units to
MPH, low limit to 5mph, high limit to 99mph and speed limit to 99mph].
Set Serial Baud Rate
:
This configuration is only required at the factory when mating the radar to
the selected speed digit display panels. Once configured, the radar keeps
the configuration even after power is removed and need not be
reconfigured.
The optional statistics package can communicate with the PC to download
saved statistics at any set baud rate. The baud rate of the radar is
automatically detected by the stats package.
Use this feature to set the baud rate of the serial data port by following the following
steps: