User's Manual

Page 12 of 13
Select the baud rate from the table below and note the key combination from the “Key #”
column in the table.
Press the “Set Baud “ key on the IR remote followed by the two digit numeric code from
the desired baud rate row picked in #3 above, followed by the “Select” key.
You may press cancel any time in the above procedure to cancel programming the new
baud rate. The new baud rate is not stored and changed till you press the “Select” key.
Your baud rate is now programmed in permanent memory and if you have speed display
panels hooked up, they will display the two digit key combination that you entered to
select the baud rate.
If you want to change the baud rate of the radar, you can simply follow the above
procedure and select a new baud rate any number of times.
Baud Rate (bps) # Data Bits # Stop Bits Parity Key #
1200 7 1 Even SET BAUD + 10
1200 7 1 Odd SET BAUD + 11
1200 7 1 None SET BAUD + 12
1200 8 1 None SET BAUD + 13
2400 7 1 Even SET BAUD + 20
2400 7 1 Odd SET BAUD + 21
2400 7 1 None SET BAUD + 22
2400 8 1 None SET BAUD + 23
9600 7 1 Even SET BAUD + 30
9600 7 1 Odd SET BAUD + 31
9600 7 1 None SET BAUD + 32
9600 8 1 None SET BAUD + 33
115,200 8 1 None SET BAUD + 43