User's Manual

Page 9 of 13
This section describes these features and how to program the values into the radar using
the IR remote.
Apply +12 V DC battery power to the radar power wires.
Stand in front of the radar, between 2 and 10 feet away and point the IR remote at the
front face of the radar (the IR receiver window is the small circular hole below the
rectangular window). Then execute the following steps to program the desired functions:
Speed Low Limit:
Use this feature to only give speed awareness feedback to vehicles over a certain limit,
for example the road speed limit. This would setup the system to not display the speeds
of vehicles that are below the limit, rather only display the speed of vehicles that are
above the limit. With panels that support the “power saving mode”, this can result in very
significant power savings and significantly extend operation time between battery
recharges.
1. Press the “LOW LIMIT” key once
[The current value will be displayed on the display]
2. Enter the numeric speed for the low limit (or use the Up/Down arrow keys)
3. Press “SET/OK” to save the limit in the radar or press “CANCEL” at any time
before “SET/OK” to cancel this operation
Speed High Limit:
Use this feature to blank out the speed display of vehicles over this limit. You can use
this feature to defeat “racing against the radar” issue.
1. Press the “HIGH LIMIT” key once
[The current value will be displayed on the display]
2. Enter the numeric speed for the high limit (or use the Up/Down arrow keys)
3. Press “SET/OK” to save the limit in the radar or press “CANCEL” at any time
before “SET/OK” to cancel this operation
Speed Limit:
Use this feature to flash the speed display of vehicles over this limit. You can use this
feature to draw attention to the speed of vehicles going over the set limit.
1. Press the “SPEED LIMIT” key once
[The current value will be displayed on the display]
2. Enter the numeric speed for the speed limit in effect at the current location
3. Press “SET/OK” to save the limit in the radar or press “CANCEL” at any time
before “SET/OK” to cancel this operation