Installation Instructions

2. If you are replacing old sink, remove old one and verify existing countertop
opening will fit your new sink by setting it temporarily.
9. Verify your sink installation channel and clips that came with the sink and follow proper
instructions below.
L-shaped single blade channel
8. Attach faucet and strainers as necessary according to the manufacturer’s instructions.
10.Place the sink upside down. Hold clip by the bracket
firmly and insert one leg at a time in 45 degree angle
to the slot in the I-channel, facing sharp teeth toward
the outer edge of the sink.
11. Attach 3 clips in front and back. 2 clips to each
side. Use extreme caution while inserting clips as
the teech are sharp and may cause injury.
12.Place the sink carefully into the cutout opening and
be sure it is properly seated. Make sure the sink rim
covers caulking all around. Then press down firmly
around perimeter of the sink rim. (Go to 13)
I-Channel System
jig
(For model 3120-8BS please see template that comes with the sink)