Installation Guide

ManualsBrandsHOUZER ManualsKitchen ApplianceContempo Gourmet Undermount 32x18x10 in. 0-Hole Single Bowl Kitchen Sink

Installation instructions

Contempo series Zero Radius Sink

General Recommendations:

Please read installation and maintenance instructions thoroughly.

Inspect your sink for any noticeable damage before installation.

Check all local applicable plumbing and building codes.

These instructions are based on application to composite material or solid surface countertop installation only;

countertop application to stone, marble, granite or butcher-block should be referred to an experienced

countertop fabricator for custom installation.

Contempo series Zero Radius Sinks are individually hand-crafted and HOUZER suggests using

experienced and professional installers only. For custom cutting of countertop and installation

of the actual sink, on-site installation is also recommended. Acceptable variances are approximately 1/8 of

an inch. Alignment to the cut-out and precise application and trimming of any adhesive sealant are critical to

a superior fit and finished look. Please take extra care in this regard.

HOUZER does not accept any liability for damage to countertop, sink fixture, faucets or personal injury

during installation. Warranty is void if installation instructions are not followed.

Tools and Materials needed:

Tape Measure Framing Square Eye Protection

Hacksaw/Jigsaw Ear Protection Silicone Adhesive Sealant

Rags Shims Wood Braces

Pencil (NOT ink) Denatured Alcohol

Be sure to use proper tools and always wear personal safety devices for your protection.

www.HouzerSink.com

Summary of content (4 pages)

PAGE 1
www.HouzerSink.com Installation instructions Contempo series Zero Radius Sink General Recommendations: Please read installation and maintenance instructions thoroughly. Inspect your sink for any noticeable damage before installation. Check all local applicable plumbing and building codes.
PAGE 2
INSTALLATION INSTRUCTIONS Please carefully read complete instructions before beginning installation. Note: These instructions are for installation with solid surface, composite material countertops. Houzer recommends professional countertop installers and is not responsible for damages to the countertop or sink during installation. 1. Unpack the new sink and check the contents of the materials supplied: (1) Sink, (12) Mounting brackets, (1) Cutout template. 2.
PAGE 3
5. Locate and drill holes on the underside of the counter top, approximately 1" from edge of the sink to be installed. Holes should be evenly spaced approximately 6" to 8" apart starting from every corner as shown in Figure 4. It is recommended to install a faucet at this point before installing the sink. 6. Loosely attach mounting brackets to the countertop, parallel to the cutout opening using the supplied mounting screws and butterfly nuts.
PAGE 4
Care and Maintenance ALWAYS • Clean everyday by thoroughly rinsing with a mild soap and warm water and wipe dry. • Rub lightly with a soft cloth in the direction of grain lines on a regular basis for additional preventive cleaning. • Keep the sink free of any standing water as this can cause a buildup of mineral deposit, which can affect the appearance of your sink. • Any stubborn stains should be removed by scrubbing in the direction of the grain with a mild abrasive such as Comet.