Installation Guide

SOMPD - 669 Soma Pull Down Faucet
304669
Instructions:
1. Flush out some water from hot and cold valve in
the wall. This will ensure smooth operation during
the faucet life.
2. Insert faucet body through deck plate and into sink
or counter.
3. Remount rubber washer followed by plastic base,
if necessary, and metal washer to faucet shank under
sink. Remount lock nut to shank and hand-tighten.
4. Be sure the faucet is aligned properly. Make final
tightening of lock nut.
5. Connect pull-out spray hose tub, being certain that
fiber washer remains in place in supply tube.
6. Connect the supply hoses to the hot and cold water
supply valves. When tightening the nut be sure
not to twist the hoses.
7. Attach counter weight to hose on spout side of loop,
just above bend ( use screws provided ).
8. Confirm that faucet operating handle is in closed
position and open supply valves, check connections
for leakage.
9. Disconnect spray head from hose and flush water
out until clear, to avoid problems with sprayhead
operation. Make sure that rubber washer remains
in place.
1. The aerator should be removed periodically and
cleaned, depending on the quality of water.
2. In order to maintain the sparkling appearance of
the finishes, wipe after each use with a soft cloth.
Use only a mild soap or household vinegar to clean
the faucet. Do not use steel wool or cleaning against
containing alcohol, acids, abrasives, etc.
Cleaning:
Operation:
1. The mixer is operated by moving the handle.
2. Swivel handle back and forward for cold and
hot water. For mixed water, keep the handle in
the middle until the desired temperature is
reached.
3. To control the water flow, pull the handle away
from the body until you reach the desired flow.
4. On kitchen faucets:
a. The handspray can be drawn approximetly
500 mm (20”) out of the spout.
b. The flow of the water is changed from
aerator to spray mode by pushing down
upon the diverter button located on top of
the handspray.
c. After the water flow has been shut off,
the handspray automatically reverts back
to aerator mode.
Max. temprature: 176 F (80 c)
Recommended pressure range: 15-88 PSI (1-6 bar)
( )
( )
( )
Houzer Inc. 2605 Kuser Road, Hamilton, NJ 08691 p 800- 800-3639, f 877-880-3654 [e-mail]