CA Prop 65

DIRECTIONS: Do not pour directly on finish. Always wipe off excess
Restor-A-Finish. Choose the color that best matches the finish of your
wood. Apply with a small pad of cloth, or (for severe scratches and
white rings) apply with super fine (0000) steel wool. When using steel
wool, always rub with the wood grain. Finishes vary in hardness, so
test pressure to be used with steel wool on an inconspicuous spot.
Cover a small area at a time and wipe dry. For best results, wait at
least 30 minutes and then apply a coat of HOWARD FEED-N-WAX to
protect and maintain the restored finish.
DO NOT USE POLYURETHANE ON TOP OF RESTOR-A-FINISH
RESTOR-A-FINISH
is a unique finish-penetrating formula that
restores the original color and luster to wood finishes while blending
out minor scratches and blemishes. It permanently eliminates white
heat rings, water marks, scratches, color fade, oxidation, smoke
damage, etc. RESTOR-A-FINISH restores the finish in one step -
without removing any of the existing finish.
KEEP OUT OF REACH OF CHILDREN
DANGER! FLAMMABLE. Contains petroleum distillates. Keep away
from heat, sparks, and flame. Before using this product in the
workplace, read the Safety Data Sheet (SDS) available online. This
product is intended for occasional use only. Intentional misuse by
deliberately concentrating and inhaling the contents may be harmful
or fatal. Reports have associated repeated and prolonged occupa-
tional overexposure to solvents with permanent brain and nervous
system damage. USE WITH ADEQUATE VENTILATION. To avoid
breathing vapors, open windows and doors or use other means to
ensure a cross ventilation of fresh air through work area. If you
experience eye watering, headaches or dizziness, increase fresh air
or wear respiratory protection (NIOSH/MSHA approved) or leave the
area. Avoid prolonged contact with skin. Close container after each
use. Do not transfer contents to bottles or unlabeled containers.
FIRST AID: If swallowed, DO NOT INDUCE VOMITING. Call
physician immediately. EYE CONTACT: Immediately flush with water
for at least 15 minutes. SKIN CONTACT: Wash with soap and water.
WARNING:This product can expose you to chemicals including
Ethylbenzene, which are known to the State of California to cause cancer.
For more information go to www.P65Warnings.ca.gov.
This product is made from
the finest raw materials
available and
manufactured to proven
formulation under strict
quality control for its
intended use on natural
wood finishes. However,
results obtained with the
use of this product under a
variety of conditions may
depend on circumstances
beyond our control. Howard
Products, Inc. and the
seller therefore disclaim
any responsibility for
expense or consequential
damage of any kind. The
only warranty extended,
expressed or implied, is for
defective workmanship or
materials. For more
ingredient information visit
www.howardproducts.com
HOWARD PRODUCTS, INC.
Paso Robles, CA 93446
(
800
)
266-9545 • www.howardproducts.com
HOWARD PRODUCTS, INC.
Paso Robles, CA 93446
(
800
)
266-9545 • www.howardproducts.com
Do not use polyurethane on
top of restor-a-finish.
Not recommended for floors
or exterior surfaces.