User's Manual

When testing the host product, all the transmitters must be operating. The transmitters can

be enabled by using publicly-available drivers and turned on, so the transmitters are

active. In certain conditions, it might be appropriate to use a technology-specific call box

(test set) where accessory devices or drivers are not available. When testing for emissions

from the unintentional radiator, the transmitter shall be placed in the receive mode or idle

mode, if possible. If receive mode only is not possible then, the radio shall be passive

(preferred) and/or active scanning. In these cases, this would need to enable activity on

the communication BUS (i.e., PCIe, SDIO, USB) to ensure the unintentional radiator

circuitry is enabled. Testing laboratories may need to add attenuation or filters depending

on the signal strength of any active beacons(if applicable) from the enabled radio(s).

FCC Warning:

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment. This device complies

with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) This device must accept any

interference received, including interference that may cause undesired operation

ISED RSS Warning:

This device complies with Innovation, Science and Economic Development Canada

licence‐exempt RSS standard(s). Operation is subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause

undesired operation of the device.

Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même

i le brouillage est susceptible d'en compromettre le fonctionnement.

ISED RF exposure statement:

This

equipment complies with ISED radiation exposure limits set forth for an uncontrolled

environment.This equipment should be installed and operated with minimum distance

20cm between the radiator& your body.This transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter.

Le rayonnement de la classe b repecte ISED fixaient un environnement non

contrôlés.Installation et mise en oeuvre de ce matériel devrait avec échangeur distance

minimale entre 20 cm ton corps.Lanceurs ou ne peuvent pas coexister cette antenne ou

capteurs avec d’autres.