User Guide

To correctly install the glide on all Hoyt bows,

first place the glide on the

cable guard bar (See fig 8).

Next, push the control cable

into the shorter front slot.

Then, push the buss cable into

the longer rear slot.

CAUTION: Do not pull bow

back without proper installa-

tion of cable guard bar and

glide.

TILLER ADJUSTMENT

Tiller is the difference in distance between the

upper limb to the string and lower limb to the

string measured from the base of the limbs

(where the limb and riser meet) at a 90 degree

angle to the string. (See fig 9)

The main function of tiller is to allow the archer to

more easily and comfortably aim during the draw

and release of the shot. Most bows will shoot best

near even tiller which means the distance from

the string to the limb is the same on top and bot-

tom. Tiller adjustments are made by adjusting

either limb weight adjustment bolt. (See draw

weight adjustment section pg. 15). Example: If

you have too much tiller on the bottom limb,

decrease the weight on the top limb or increase

fig 8

Control

Cable

Buss

Cable