2823 3003 EASYCLEAR 3000 ? Hozelock Ltd. Midpoint Park, Birmingham B76 1AB. England Tel: +44 (0) 121 313 1122 info@hozelock.com www.hozelock.
E 1 D B G 2 3 J F K A I C H 4A 4B 5 L M 7 6 N P P O 8 Q R S
9 U T 10 V W V W V X Y Z Z 10A
INSTALLATION AND OPERATING INSTRUCTIONS. READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING INSTALLATION. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. The Hozelock Cyprio EasyClear™ Fountain or Waterfall pump is designed for submersible use in outdoor ponds. It is an integrated unit that provides Mechanical & Biological Filtration with an Ultra Violet Clarifier, Fountain or Waterfall.
occurs, switch off the power at the mains supply to the unit. If it is the pump that has activated the Overload Protection, check for the cause (it is usually debris blocking the inlet of the pump or obstructing the impeller). Remove the obstruction and wait 15 minutes for the unit to cool down and. Then switch it on again.
coloured blue or black. The GREEN/YELLOW lead should be connected to the EARTH terminal which may be marked with an 'E' or coloured green or green/yellow. enough cable for positioning the product in the desired location in the pond. • If an extension cable is required, this should be connected to the end of the unit cable using a weatherproof connector. The joint must be positioned in a suitable weatherproof housing. The extension cable should be of 3 core 0.
The Bell Fountain creates a decorative waterbell. The size of the bell can be adjusted to suit your needs by rotating the Fountain Flow Adjuster (Fig 3-K). Waterfall Only Operation (Fig 4-B for general installation guide) Position the pump as previously described. Attach a suitable length (3m maximum) of 25 mm (1”) hose to the waterfall hose tail (Fig 1-G) and secure with a suitable hose clip and position the outlet end of the hose in the desired position.
restart (Fig 8-S). Warning! Ensure that the quartz tube is not damaged before refitting. Lamp Replacement Follow the below procedure if the lamp needs replacing or does not illuminate: Change the lamp at the start of the new season. Even though the lamp still glows it may not be giving out any useful UV radiation. How well the EasyClear™ performs is related to the strength of the UV radiation produced. This will slowly decline from the day your lamp is switched on.
the general maintenance notes. Depending on pond water conditions, cleaning may be required more frequently. Once a year- Completely disassemble the unit including the Rotor Assembly as described in the general maintenance notes, and wash all components in clean, freshwater. Replace worn or broken parts. Winter Storage When not in use, the unit should be removed, thoroughly washed and cleaned, dried and stored in a dry frost protected area.
Fault Finding Please read the safety sections of these instructions before carrying out any remedial action on the EasyClear! It may also be necessary to refer to the maintenance section of these instructions. LOW FLOW FROM PUMP a – The foams may be blocked and require cleaning b - Ensure the outer cage is clean. c - Clear any blockages and adjust the flow controls. d - Check white flap inside pump chamber moves freely. e - Ensure rotor is clean and moves freely.
Hozelock Ltd. Midpoint Park, Birmingham B76 1AB. England Tel: +44 (0)121 313 1122 info@hozelock.com www.hozelock.com 33854-005 This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.