user manual

Removal and Installation
8-2
HP DesignJets 1050C and 1055CM Printers Service Manual
Introduction
This chapter is a step by step guide to the removal and installation
of the key components in the printer. You may find it useful to tick off
the steps as they are performed. Use the illustration at each
procedure to identify the parts referred to in the text.
The procedures appear in order of removal. So the whole machine
can be stripped down by starting at the beginning of this chapter
and working through the subsequent procedures.
NOTE Before using this chapter to remove and install a new component,
always make sure that you have performed the relevant service
test from Chapter 4. If the test passes you will not need to replace
the component.
Safety Precautions
(Safety symbols - Immediately after the table of contents.)
Review WARNING and CAUTION symbols and instructions before
you service the printer. Follow these warnings and cautions for your
protection and to avoid damaging the printer.
WARNING Serious shock hazard leading to death or injury may result if you
do not take the following precautions:
Ensure that the ac power outlet (mains) has a protective earth
(ground) terminal.
Switch the plotter off, and disconnect it from the power source
prior to performing any maintenance.
Prevent water or other liquids from running onto electrical
components or circuits, or through openings in the module.