user manual
3-4
C
H
A
P
T
E
R
3:
C
O
N
F
I
G
U
R
I
N
G
T
H
E
E
D
G
E
R
O
U
T
E
R
M
O
D
U
L
E
Configuring the
Carrier in a
Managed ONline
Hub
This section describes how to use network management commands to
configure ONline carriers installed in an ONline System Concentrator. This
section contains the following topics:
■
Selecting a Network
■
Saving the Configuration
When you install the carrier in a hub with a management module installed,
the network defaults to isolated mode (Isolate_1). You must assign a
network as described below.
Selecting a Network
The engine connects to the backplane through a carrier module port on the
ONline carrier. You can assign the carrier module port to:
■
One of three Ethernet backplane networks
■
Isolated mode
For details on backplane networks, refer to the
ONline System Concentrator
Installation and Operation Guide
(Document Number 17-00417).
To assign the carrier module ports to a network using the network
management software, use the following command:
ONline> set port
slot.port
network {ethernet_1 ... _3}
{isolated_1}
For example, the following command sets port 1 in the ONline carrier
installed in slot 3 to the Ethernet 2 backplane network:
ONline> set port 3.1 network ethernet_2
Port 03.01 network id set to ETHERNET_2
Saving the
Configuration
To save configuration changes, use the SAVE command. For example, the
following command saves all configuration changes:
ONline> save all
If you do not save module settings, you may lose configuration data.