user manual

5-3
Cisco ICS 7750 Installation and Configuration Guide
78-14165-03
Chapter 5 Operating the Cisco ICS 7750
Accessing the System
associated with transmitting voice traffic over an IP network. For
additional information, see the Accessing Cisco CallManager” section
on page 5-8.
Cisco IOS software command-line interface (CLI)—You can use Cisco IOS
software to configure ASIs, MRPs, and SSPs. For additional information, see
the Accessing the Cisco IOS CLI on ASIs, MRPs, and the SSP Through
Telnet” section on page 5-11.
Microsoft Windows software interfaces:
Terminal Services Client—You can use Terminal Services Client to
access the SPE310 desktop and perform standard Windows file
management operations on the SPE310. For additional information, see
the Accessing SPE310s” section on page 5-8.
Terminal Services Client is packaged with Windows 2000. Terminal
Services Client is also available for downloading and installing on to
other Windows operating systems. See the “Installing Microsoft
Terminal Services Client” section on page 2-19 for installation
instructions.
Terminal emulation interfaces—You can use native tools such as Telnet
and HyperTerminal to configure system cards. You can also connect
directly to the system alarm processor (SAP) through a console or
modem connection and troubleshoot system cards. For additional
information, see the Accessing Processor Cards Through the SAP”
section on page 5-12.
Simple Network Management Protocol (SNMP)–based Management
Information Base (MIB)—You can use the SNMP MIB to manage the
Cisco ICS 7750 with software such as CiscoWorks2000 and HP OpenView.
(For additional information, see the “Using Network Management Solutions
with the Cisco ICS 7750” section on page 6-146.)