user manual

Chapter 5 Operating the Cisco ICS 7750
Setting Security Privileges
5-30
Cisco ICS 7750 Installation and Configuration Guide
78-14165-03
page 5-27, and hostname is the host name of the card. For example, an
SSP configuration file could be named Backup1_Switch, and an MRP300
configuration file could be named Backup1_R00ffff900073.
Step 7 Repeat Step 6 for the SSP and for every Flash-based MRP or ASI card (MRP300,
MRP3-8FXS, MRP3-16FXS, or MRP3-8FXOM1) in the chassis.
Step 8 If you have configured VLAN functionality on the Cisco ICS 7750, you may also
back up the file vlan.dat from the SSP Flash memory. This file stores VLAN
configuration information.
The procedure for backing up the vlan.dat file is the same as the procedure that is
used for copying a Flash file to a network server. To copy the vlan.dat file to a
TFTP network server, use the following command in EXEC mode from the
command prompt on the SSP:
Switch#copy flash:vlan.dat tftp://<ip address of server>/<dir>/<filename>
where <ip address of server> is the IP address of the TFTP server, <dir> is the
directory name on the TFTP server, and <filename> is the filename to write on the
TFTP server.
Setting Security Privileges
To ensure that only persons with proper authorization have access to sensitive
information, you can designate system passwords during initial configuration of
ICS System Manager.
Note For additional information, refer to the ICS System Manager Online Help.