user manual
Quick Reference Service Manual
7
HP DesignJet 2500CP and 2000CP Printers
040xxx Ć Press ENTER and switch the printer OFF. Make sure the MIO
card is installed correctly and switch the printer ON again. If this error code continues to
appear then replace the MIO Card. If the system error continues to appear after replacing the
MIO card, replace Electronics Module.
040601 Ć Install latest version of the MIO Card.
050000 Ć Clean Mark Encoder. Check Line Sensor is installed/connected
correctly. Perform Service Accuracy Calibration. Replace lens cover which is installed on the
line sensor. Replace Line Sensor Assembly. Replace Trailing Cable. Replace Carriage
Assembly. Replace Electronics Module.
060000 Ć Close the Window if it is open. Move the printer to a location
with less light. The Printer MUST be kept away from direct intense sunlight or a spotlight.
Replace the Line Sensor Assembly. Replace the Trailing Cable. Replace the Carriage
Assembly. Replace the Electronics Module.
060100 Ć Calibrate Line Sensor. Clear EEROM and perform all
calibrations again. Replace Electronics Module and perform all calibrations
060200 Ć Incompatible Firmware and Carriage PCA. Upgrade Firmware.
060300 Ć Incompatible Firmware and Line Sensor. Upgrade Firmware.
060400 Ć Incompatible Carriage PCA and Line Sensor. Replace Line
Sensor. Calibrate Line Sensor.
060500 Ć Calibrate Line Sensor.
07xxxx Ć Firmware Error. Make sure you have the latest version of the
Flash SIMM (firmware) installed or upgrade the firmware revision of the Flash SIMM. If the
error code remains after installing the latest Flash SIMM then report the error to the HP
Response Center or the nearest HP Support Office, stating the following information:
D Model and Serial Number of the printer.
D the complete error number.
D service print ( ).
D plot file where the error has occurred.
D additional comments about the usage, the setting, etc..
08xxxx - PostScript Error. Refer to Error Code 07xxxx
080001 - Hard Disk Drive installed without PostScript.