user manual
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures
- Preliminary replacement requirements
- Component replacement procedures
- Service tag
- Computer feet
- Battery
- Webcam/microphone module
- Optical drive
- Memory module
- TV tuner module
- RTC battery
- Hard drive
- WLAN module
- Switch cover and keyboard
- Power button board
- Display assembly
- Speaker
- Bluetooth module
- Top cover
- Modem module
- Audio/infrared board
- USB board
- Power connector cable
- System board
- TV tuner module cable
- Modem module cable
- Fan/heat sink assembly
- Processor
- Setup Utility
- Specifications
- Computer specifications
- 15.6-inch, WXGA display specifications
- 16.0-inch WXGA BrightView display specifications
- 16.0-inch WXGA AntiGlare display specifications
- Hard drive specifications
- Blu-ray ROM DVD±R/RW SuperMulti Double-Layer Drive specifications
- DVD±RW SuperMulti Double-Layer Combo Drive specifications
- System DMA specifications
- System interrupt specifications
- System I/O address specifications
- System memory map specifications
- Screw listing
- Backup and Recovery
- Connector pin assignments
- Power cord set requirements
- Recycling
- Index
15. Slide the webcam/microphone module to the right, and then lift it from the display (2).
16. Disconnect the webcam/microphone module cable (3) from the webcam/microphone module.
17. Remove the webcam/microphone module. The webcam/microphone module is available using
spare part number 512827-001.
18. Disconnect the display inverter from the double-sided tape securing it to the display, and then
release the display inverter (1) as far from the display bezel as the display panel cable and backlight
cable allow.
19. Disconnect the backlight cable (2) and display panel cable (3) from the display inverter.
20. Remove the display inverter. The display inverter is available using spare part number
488317-001.
21. If it is necessary to remove the display panel cable, remove the adhesive reinforcement strip (1)
from the connector, and then disconnect the cable from the connector (2).
22. Remove the tape that secures the display panel cable to the bottom of the display (3).
72 Chapter 4 Removal and replacement procedures