user manual
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures
- Preliminary replacement requirements
- Component replacement procedures
- Service tag
- Computer feet
- Battery
- Webcam/microphone module
- Optical drive
- Memory module
- TV tuner module
- RTC battery
- Hard drive
- WLAN module
- Switch cover and keyboard
- Power button board
- Display assembly
- Speaker
- Bluetooth module
- Top cover
- Modem module
- Audio/infrared board
- USB board
- Power connector cable
- System board
- TV tuner module cable
- Modem module cable
- Fan/heat sink assembly
- Processor
- Setup Utility
- Specifications
- Computer specifications
- 15.6-inch, WXGA display specifications
- 16.0-inch WXGA BrightView display specifications
- 16.0-inch WXGA AntiGlare display specifications
- Hard drive specifications
- Blu-ray ROM DVD±R/RW SuperMulti Double-Layer Drive specifications
- DVD±RW SuperMulti Double-Layer Combo Drive specifications
- System DMA specifications
- System interrupt specifications
- System I/O address specifications
- System memory map specifications
- Screw listing
- Backup and Recovery
- Connector pin assignments
- Power cord set requirements
- Recycling
- Index
d. Display assembly (see Display assembly on page 68).
e. Top cover (see
Top cover on page 80).
f. USB board (see
USB board on page 85).
g. System board (see
System board on page 88).
Remove the power connector cable:
1. Remove the power connector cable (1) from the clips and routing channel (2) built into the base
enclosure.
2. Remove the Phillips PM2.5×7.0 screw (3) that secures the power connector and bracket to the
base enclosure.
3. Remove the power connector bracket (4).
4. Remove the power connector cable assembly (5).
Reverse this procedure to install the power connector cable.
Component replacement procedures 87