user manual

b. Place the graphics cables in the hard drive bays.
Place the CPU, memory power, and rear system fan cables over the chassis edge.
TIP: Use the CPU and memory power cables to hold up the shorter rear system fan cable.
The following figure presents an example of these steps.
10. Slide the system board forward as shown in the following figure .
Figure 5-104 Removing the system board
11. Using the CPU heatsinks as handles, lift the system board straight up and then tilt the board to
remove it from the chassis
2
. Do not damage the cables and rear panel connectors.
NOTE: If desired, remove system board components such as the CPU heatsinks and the CPUs.
160 Chapter 5 Replacing components ENWW