user manual

Airflow guide
This section describes how to remove and install the chassis airflow guide.
Removing the airflow guide
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the side access panel (see
Removing the side access panel on page 75).
3. Remove the airflow guide by lifting firmly on the handle at the green touch point
, and then rotating
the airflow guide upward
2
as shown in the following figure.
Figure 5-4 Releasing the airflow guide
4. Disengage the airflow guide tabs from the rear chassis slots , and then lift the airflow guide from
the chassis
2
as shown in the following figure.
Figure 5-5 Removing the airflow guide
76 Chapter 5 Replacing components ENWW