user manual

Install the duplexer

You can print on both sides of a sheet of paper automatically. For information on using

the duplexer, see

Print on both sides (duplexing).

To install the duplexer

Ÿ Slide the duplexer into the printer until the unit locks into place. Do not press the

buttons on either side of the duplexer when installing the unit; use them only for

removing the unit from the printer.

Install Tray 2

NOTE: This feature is available with some models of the printer.

Tray 2 can hold up to 250 sheets of plain paper. For ordering information, see HP

supplies and accessories.

To install Tray 2

1. Unpack the tray, remove the packing tapes and materials, and move the tray to the

prepared location. The surface must be sturdy and level.

2. Turn off the printer, and disconnect the power cord.

3. Set the printer on top of the tray.

CAUTION: Be careful to keep your fingers and hands clear of the bottom of

the printer.

4. Connect the power cord and turn on the printer.

5. Enable Tray 2 in the printer driver. For more information, see

Turn on accessories

in the printer driver.

Install the accessories