user manual

537502-001 — Removing and Replacing a Hard Disk Drive 9
7 Slide the cage toward the bottom of the computer until
it locks into place.
8 Insert and tighten the two screws that secure the cage
in the computer.
9 Squeeze the top and bottom of the PMD connector
and insert it into the top cage.
10 Set the computer upright.
11 Hold the front panel over the computer, and then
press the left side of the panel, inserting the tabs into
the computer. Swing the right side of the panel toward
the computer, and then press it into the computer.
12 Hold the side panel over the side of the computer with
the front edge of the panel about 2.5 cm (1 inch) from
the front of the computer.