user manual

After removing the Fuser Assembly, remove the contact plate
from the rear of the printer, as follows:
1 Remove the (1) screw from the sheet metal Guide Plate Cover.
(This screw is behind the Fuser Assembly, see Figure 6-52,
callout 1).
2 Remove the Guide Plate Cover by freeing the front edge,
lifting upward, and sliding the cover out the rear of the printer.
Note
Do not lose any of the (6) rollers the Guide Plate
Cover holds in place.
(continued on next page)
Figure 6-52 Guide Plate Cover Screw
6-63 Removal and Replacement