® HP Pavilion V50 Display
® HP Pavilion V50 Display User's Guide
User’s Guide Notice The information contained in this document is subject to change without notice. ® Hewlett-Packard Company makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. HP shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material.
Contents ♦ Introduction .....................................1 Regulatory Information.................... 13 For Your Safety ............................................................................. 2 FCC Statement .............................................................................. 13 Installation ........................................... 5 X-Ray Radiation Notice .............................................................14 Unpacking the Display......................................
iv HP Pavilion V50 Display User’s Guide
Introduction ♦ Front-panel controls The HP Pavilion V50 Display is a high-resolution, multiscan color monitor designed for use with HP Pavilion and other computers. The display complies with EPA ENERGY STAR® standards and includes automatic power-management features.
For Your Safety For your safety and the protection of your display, follow these precautions: ♦ Always connect the display to a grounded, three-prong power outlet. Use only the factory-supplied power cord. W arning: To completely disconnect power from the display, you must remove the power cable from the power socket. ♦ To prevent electrical shock, do not remove the back cover of the display. The cover should be removed only by qualified service personnel.
If any of the following conditions occur, unplug the display and contact a qualified service technician: ♦ The power cord or plug is frayed or damaged. ♦ You have spilled liquid into the display. ♦ The display has been exposed to rain or water. ♦ The display does not operate correctly when the operating instructions are followed. ♦ The display has been dropped, or the cabinet has been damaged. ♦ The performance of the display changes abruptly.
4 HP Pavilion V50 Display User’s Guide
Installation Follow the instructions in this chapter to install your HP Pavilion V50 Display.
Installing the Base Pedestal 3 Insert the seven tabs on the base pedestal into the seven slots found on the bottom of the monitor. 1 4 Push the base pedestal toward the front of the Turn the monitor upside down on a sturdy surface. (Don't place it screen-side down; the glass can be scratched.) 2 Position the base pedestal with the latch facing the back of the monitor. 6 HP Pavilion V50 Display User’s Guide monitor until it snaps into position.
4 Connect the video cable on the monitor to the 15-pin video graphics connector on the rear panel of the computer, and tighten the fastening screws. (If you have an HP Pavilion computer, this port is marked in orange. For other computers, check your computer manual for the video port location.) Note: Don't force the cable into the connector; line it up carefully so you don't bend the pins.
Connecting the Speakers Tilt speakers toward front and push down The display is designed for use with speakers supplied with HP Pavilion computers. To connect the speakers: 1 Identify the left and right speakers. You can tell which side a speaker fits onto by its mounting pegs. The side of the speaker with mounting pegs fits against the side of the display. 2 Fit the pegs of the right speaker into the corresponding holes on the right side of the display.
Changing Display Settings Your Pavilion V50 Display is capable of displaying several different resolution settings and may be adjusted for different ambient lighting conditions (compatible resolutions are shown in the Technical Specifications section of this manual). Depending on the mode you choose in the Display Settings window on your PC, you may need to make minor adjustments for the image size and center. To make these adjustments, refer to the following table.
Front Panel Controls Icon 10 Control Function Vertical Position Centers image vertically Vertical Height Sizes image vertically Horizontal Position Centers image horizontally Horizontal Width Sizes image horizontally Contrast Adjusts screen contrast Brightness Adjusts screen brightness Power Switch Turns monitor on and off HP Pavilion V50 Display User’s Guide Icon RESET Control Function Pincushion Adjusts any tapering or bowing of the sides Trapezoid Adjusts the top and bottom of t
Adjusting Settings ♦ Push "select" to choose a function. ♦ Push keys with up or down arrows to increase or decrease the setting for the selected function. ♦ Push "select" to move to another function. ♦ Simultaneous pressing of keys with up and down arrows ("RESET") resets all adjustments to factory settings.
Technical Specifications Monitor Specifications . CRT description 90º deflection, light transmission, 57% phosphor, P22 medium short, 0.28 mm dot pitch (non-glare/antistatic, MPR Cpmpliant) CRT size 15 in (38.1 cm) Maximum viewable area 277 mm (H)×208 mm (V) 10.9 in×8.1 in Maximum diagonal visible image area 13.7 in or 34.8 cm Weight unpacked 27.6 lb or 12.5 kg Dimensions (W×H×L) 368×392.8×395 mm 14.5 in×15.5 in×15.
Regulatory Information FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
X-Ray Radiation Notice General Notice When operating, this product emits X-rays; however, it is well shielded and meets the safety and health requirements of various countries, such as the Radiation Act of Germany and the Radiation Control for Health and Safety Act of the United States. Note: This display is a Class 1 LED product. Radiation emitted by this product is less than 0.1 mR/hr (1µSv/hr) at a distance of 10 centimeters from the surface of the cathode-ray tube.
Declaration of Conformity Manufacturer's Name: Hewlett-Packard Company Manufacturer's Address: 10500 Ridgeview Ct.
P/N: 5030010004
Copyright © 2000 Hewlett-Packard Company. All rights reserved.
