user manual

Installing the USB device
▲
Insert the USB device into the USB port in the secure USB compartment. See the following
illustration for the location of the ports in the secure USB compartment.
Figure 2-2 Secure USB compartment port location
Replacing the secure USB compartment cover
To replace the secure compartment cover:
1. Place the cover on top of the unit so it is offset about 1/2–inch toward the rear of the unit, allowing
the tabs on the cover to align and insert into the slots on the chassis (1).
2. Slide the cover toward the front of the unit until it locks in place and the cover is flush with the front
panel of the chassis (2).
3. Replace the screw (3).
Figure 2-3 Replacing the secure compartment cover
To remove USB devices from the secure compartment, reverse the previous procedures.
ENWW Installing USB devices in the secure USB compartment 11