Upgrade and Service Guide

Upgrading and Servicing Guide 15

2 On the right side of the chassis, do the following:

a Slowly pull out the square-cornered edge of the inlay (O, near the rear of the

chassis) to free the three snaps along the right side of the inlay.

b Continue to slowly pull out the edge of the inlay to free the two columns of three

snaps located on each side of the middle of the inlay.

c Holding the inlay near to the panel, slide the inlay toward the back of the chassis

to free it.

d Set the inlay aside.

This completes the steps to remove the inlay. Continue with step 3 to access the SATA

backplane.

To install the inlay, see “Replacing the right side access” on page 18.

CAUTION: To avoid damaging the inlay, do not pull out the inlay more than

2.54 cm (1 inch) away from the panel.