User's Manual

22 CHAPTER 2: HARDWARE INSTALLATION
You should leave the Authentication Method as its default: Auto if your
ISP doesn’t specify this parameter.
If your ISP allocates fixed or static IP information, you need the following
information:
If your ISP allocates IP information dynamically over a protocol other
than PPPoE, you do not need any further information. This configuration
is typical of cable connections.
Powering Up the
Router
To power up the Router:
1 Plug the power adapter into the power adapter socket located on the
back panel of the Router.
2 Plug the power adapter into a standard electrical wall socket.
IP Address : ____.____.____.____
Subnet Mask : ____.____.____.____
Default Router address : ____.____.____.____
DNS address : ____.____.____.____