Reference Guide

HP AdvanceStack LanRover/10A Module by Shiva Installation and Reference Guide 3
Installing a LanRover/10A by Shiva Module into a Slot
To install the module into the Remote 2C, HP Switching Hub, or HP Switch, follow these steps:
1. If you are installing the module into the Remote 2C, you do not need to remove power. For other
products, such as the HP Switching Hub or HP Switch, verify that the power cord has been
removed.
2. Remove the cover plate on a slot:
3. Insert the LanRover/10A by Shiva into a slot. Note that the module has matching color handles
with the color swatch on the back of the unit the module inserts in.
4. Push the extractor handles down.
5. Tighten the two screws that hold the module in place. Be careful not to overtighten the screws.
Loosen these screws Loosen these screwsor
Back of
Remote 2C
extractor handles
Color swatch on
Remote 2C
Color swatch on
extractor handles