Reference Guide

HP AdvanceStack LanRover/10A Module by Shiva Installation and Reference Guide 9
Where to Go From Here
You are now finished installing the module and connecting cables. You need to configure the
LanRover/10A using the included software, Quick Setup Wizard which will take you approximately
15 minutes.
When you run the Quick Setup Wizard, it asks you to connect your modems and connect to an
Ethernet or 100VG network. The Wizard automatically determines if you are running an IP or IPX
network, it discovers all of your modems connected and their manufacture type. Then the Wizard
run tests from modem to modem after you provide phone numbers. The Wizard provides two tests
for the modems: a short test and a long test.
The short test will dial-out from one port and back into another. Every port will be tested for both
dial-in and dial-out and the results presented. The long test will require you to select two ports to
test. The Wizard will then attempt to bring up a connection between the two ports and continually
transfer a file between the two until you stop the test. While the test is running the Wizard will display
the connection speed, the number of bytes transmitted and received, and the number of CRC errors.