Reference Guide

2. Verify That the Hub Works
Before mounting the hub, verify that the hub operates correctly by following
these three steps:
1. Plug the power cord into the hub’s power cord receptacle and into
an AC power source.
Caution If your installation requires a different power cord than the one
supplied with the hub, be sure to use a power cord displaying the
mark of the safety agency that defines the regulations for power
cords in your country. The mark is your assurance that the power
cord can be used safely with the hub.
Note The hub does not have a power switch; it is powered on when the power
cord is plugged in. The hub’s power supply automatically adjusts to any AC
power source between 100-127 volts and 200-240 volts. There are no voltage
range settings to configure.
power receptacle
on the back of the
hub
Installing the
HP AdvanceStack Hub
Installing the HP AdvanceStack Hub
1-6