Reference Guide

1-5
Installation
Removing the Module
Installation
Removing the Module
The module is removed from the hub by reversing the installation steps
described earlier in this document. To remove the module, follow these steps:
1. Remove power from the hub by unplugging the power cord.
2. Unscrew the two captured screws holding the module.
3. Slide the handle (to the left) into the open position.
4. Pull the module out of the slot.
Warning 5. Replace the cover plate over the slot using the two screws that
hold it in place. Be careful not to overtighten the screws. When
using the hub, the cover plate must always be installed. This is
required not only for safety, but also to ensure proper hub
cooling.