Reference Guide

2-2
Graphical Software
HP Stack Manager Extended Features
Graphical Software
A description of each extended feature follows on the pages below. For
specific information about how to use a feature, consult the online help in
HP Stack Manager.
Module Bundle Connection
Use this feature if you have purchased the HP Dial-A-LAN Bundle or the
HP Router 210 Bundle to connect to the console for the respective daughter
card.
Bridge Configuration
After you click on the Bridge icon and click on Port Settings, you can enable
or disable the bridge. See page 1-4 for important information on multiple
bridges in your 100VG network before using this feature.
IP Configuration
The IP Configuration icon is used to define the parameters necessary for the
hub to communicate with a network management station using SNMP in a
TCP/IP network.
Network Test
The Network Test icon enables you to perform Ping, IPX, and Link network
tests. These tests are used to verify the connection between the hub and a
specified network device. The devices tested must support the test(s) by being
able to send appropriate response packets.
The Ping test sends Internet Control Message Protocol (ICMP) Echo Request
(“ping”) packets to another node with the specified IP address and waits for
Echo Response packets in return.
The IPX test sends IPX test packets to the specified IPX device and waits for
an IPX test packet in return.
The Link test sends IEEE 802.2 Test command packets and waits for an IEEE
802.2 Test response packet in return.