Reference Guide

2-3
Graphical Software
HP Stack Manager Extended Features
Graphical Software
Factory Reset
When you install an HP 100VG SNMP/Bridge Module in your hub, the Reset
function offers an additional reset option, Factory Reset. Use this reset option
to return the hub and the HP 100VG SNMP/Bridge Module to the original
factory configuration. All configuration except the IP configuration is
returned to the factory values. The factory reset also causes the hub to perform
its self-test, and then causes the following results:
■ all network ports are enabled
■ any configured password is deleted
■ the system name, system location, and system contact are deleted
■ the authorized managers list is cleared and the configuration is reset to
“Allow management from any address”
■ the IP configuration is not changed
Additional Security Features
With the HP 100VG SNMP/Bridge Module installed, you can create a list of
authorized managers and specify a password for the hub.
Authorized Mangers List
An authorized managers list that specifies the network addresses of the SNMP
management stations authorized to manage the hub and whether they should
be sent SNMP event alarms.
Password Protection
Password protection that limits access to the hub configuration from both HP
Stack Manager and HP Interconnect Manager. (HP Stack Manager can be run
through out-of-band management only.) The HP 100VG SNMP/Bridge Module
also has an external button that can be used to clear a configured password
if you forget it. See “Clearing a Password” on page 1-6.