Reference Guide

1-1

Installation

■ Installing the Module

■ Removing the Module

■ Clearing a Password

Installing the Module

The HP 100VG SNMP/Bridge Module is installed in the 100VG Expansion Slot

on the back of an HP AdvanceStack 100VG Hub (100VG hubs are listed on

page iii).

Warning Before installing the HP 100VG SNMP/Bridge Module, unplug the

HP AdvanceStack Hub from the power source. Electrical shock could

result if you attempt to install the module without unplugging the hub.

Caution Static electricity can severely damage the sensitive electronic components on

the module. When installing the module in your hub, follow these procedures

to avoid damage from static electricity:

■ Handle the module by its edges and avoid touching the components and

the circuitry on the board.

■ Equalize any static charge difference between your body and the hub by

wearing a wrist strap and attaching it to the hub’s metal body, or by

frequently touching the hub’s metal body while you are installing the

module.