Maintenance and Service Guide
Table Of Contents
- Product description
- Getting to know your computer
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for authorized service provider parts
- Component replacement procedures
- Preparation for disassembly
- Bottom cover
- Battery
- Hard drive
- WLAN module
- Solid-state drive
- Optane memory module
- Memory module
- Solid-state drive board
- Card reader board
- USB board
- Audio board
- TouchPad button board
- Fingerprint reader
- Fan
- Heat sink
- System board
- Display assembly
- Power connector (DC-in) cable
- Speakers
- Top cover with keyboard
- Component replacement procedures
- Using Setup Utility (BIOS)
- Using HP PC Hardware Diagnostics
- Backing up, restoring, and recovering
- Specifications
- Power cord set requirements
- Recycling
- Index
4. If it is necessary to remove the bracket from the hard drive, remove the Phillips M3.0 × 3.0 screw (1) that
secures the bracket to the drive, rotate the bracket away from the drive (2), and then pull the bracket o
the drive (3).
5. If it is necessary to remove the board from the hard drive, disconnect the hard drive cable from the ZIF
connector on the hard drive board (1), and then pull the board o the drive (2).
Reverse this procedure to reassemble and install the hard drive.
34 Chapter 5 Removal and replacement procedures for authorized service provider parts