Maintenance and Service Guide

Solid-state drive board
Table 5-8 Solid-state drive board and cable descriptions and part numbers
Description Spare part number
Solid-state drive board L52026-001
Solid-state drive cable L52025-001
Before removing the solid-state drive board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 29).
2. Remove the bottom cover (see Bottom cover on page 30).
3. Remove the battery (see Battery on page 32).
4. Remove the solid-state drive (see Solid-state drive on page 37).
Remove the solid-state drive board:
1. Disconnect the cable from the ZIF connector on the solid-state drive board (1).
2. Remove the three Phillips M2.0 × 2.8 screws (2) that secure the board to the computer.
3. Remove the solid-state drive board from the computer (3).
Reverse this procedure to install the solid-state drive board.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts