Maintenance and Service Guide

Solid-state drive
Description Spare part number
Solid-state drive, PCIe:
●
512 GB L25984-001
●
256 GB L25983-001
Solid-state drive, SATA-3, TLC:
●
256 GB L25982-001
●
128 GB L25981-001
Optane memory module, 16 GB L34406-001
Solid-state drive bracket L24488-001
Solid-state drive board L24487-001
Before removing the solid-state drive, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Remove the rubber feet (see Computer feet on page 31).
4. Remove the bottom cover (see Bottom cover on page 33).
5. Remove the battery (see Battery on page 35).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE: Solid-state drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to install the solid-state drive.
Component replacement procedures 41