Instruction Manual

1
The blinking behavior is an on/off cycle once every 1.6 seconds, approximately.
Ethernet Switch E6600 Components, LEDs, and Buttons
Front Panel Components
DescriptionItem
Console port1
Auxiliary port2
10/100/1000Base-T RJ-45 ports 1 through 24
(numbered from top to bottom, left to right)
3
10/100/1000 mini-GBIC dual-personality ports 21 through 244
Front Panel LEDs and Buttons
StatusDescriptionItem
Green = The switch is operating correctly.Power LED1
Off = The switch is not operating correctly or is not receiving power.
Orange = The switch has encountered a fatal hardware failure or has failed its
self-test. This LED comes on briefly after the switch is powered on or reset, at the
beginning of switch self test.
Fault LED2
Blinking orange = A fault has occurred on the switch, one of the switch ports, or
the fan. The status LED for the component with the fault will blink simultaneously.
If just the Fault LED is blinking, the switch could be attached to an RPS but not
receiving power.
Off = Indicates that there are no fault conditions on the switch.
PS:PS, Temperature, Fan,
and Test Status LEDs
3
Green = The switch is receiving power.
Blinking orange = A fault has occurred on one of the power supplies. The PS Status
LED, Fault LED, and on the back of the switch the failed power supply LED (PS1 or
PS2) will all blink simultaneously.
Off = The switch is not receiving power.
Temperature:
Ethernet Switch E6600 Components, LEDs, and Buttons 161