HP Engage Imaging Barcode Scanner II User Guide
Selecting the interface type
After connecting the barcode scanner to its host, scan the appropriate barcode for your system’s interface
type.
The barcode scanner supports the following host interfaces:
● RS-232 STD
● RS-232 WN
● IBM46XX port 9b (specic cable required)
● USB HID POS
● USB Toshiba TEC
● USB (Keyboard, COM, OEM)
● USB Composite (Keyboard + COM)
● USB for Magellan Scanners
● Keyboard Wedge
Conguring the interface
Scan the appropriate programming code from the following list to select the interface type for your system.
NOTE: Unlike some other programming features and options, interface selections require that you scan only
one programming barcode label. Do not scan an Enter or Exit barcode before scanning an interface selection
barcode.
Some interfaces require the scanner to start in the disabled state when turned on. If you need to perform
additional scanner conguration while in this state, pull the trigger and hold for 5 seconds. The scanner
changes to a state that allows programming with barcodes.
6 Chapter 2 Setting up and using the scanner