HP Engage Imaging Barcode Scanner II User Guide

1. Scan an Enter or Exit barcode once to enter Programming Mode.
2. Scan the parameter settings.
3. Scan the Enter or Exit barcode to accept the changes. This scan exits programming mode and returns
the barcode scanner to normal operation.
Resetting product defaults
If you want to restore the barcode scanner to its initial conguration, scan the following barcode.
NOTE: Factory defaults are based on the interface type. Make sure that the barcode scanner is congured
for the correct interface before scanning this label. For more information, see Selecting the interface type
on page 6.
Reset default settings
Numlock
This option species the setting of the Numlock key while in keyboard wedge interface. This only applies to
alternate key encoding interfaces. It does not apply to USB keyboard.
Enter or exit programming mode
— — — — — — — — — — — — — — — — — — — — — — — —
Numlock = Numlock key unchanged (default)
— — — — — — — — — — — — — — — — — — — — — — — —
Numlock = Numlock key toggled
14 Chapter 2 Setting up and using the scanner