HP Engage Imaging Barcode Scanner II User Guide

3 Light and beep indications
The scanner’s beep sounds, and its illumination ashes or changes color to indicate various functions or
errors on the barcode scanner. A green spot also lights to indicate a good read. The following table lists these
indications.
Table 3-1 Light and beep indications
Indication Light Beep
Power up Upper light blinks on turn on, however, this may be too
rapid to view. With a USB interface, the light blinks until
pairing with the host is completed.
Scanner beeps four times at highest
frequency and volume when turned on.
Good read Upper green light comes on for programmed time
(default). You can congure light behavior for this
indication using the HP Barcode Scanner D-Series
Conguration Utility.
One beep at current frequency, volume,
monotonal or bitonal setting upon a
successful label scan. You can also
upload custom jingles with the HP
Barcode Scanner D-Series Conguration
Utility.
ROM failure 200 ms on or 200 ms o. Scanner sounds one error beep at
highest volume for 200 ms.
Limited scanning label read n/a Scanner chirps six times at the highest
frequency and current volume.
Scanner disabled The light blinks continuously 100 ms on or 900 ms o. n/a
20 Chapter 3 Light and beep indications