HP Engage One Column Printer User Guide

3 Conguring the printer
The conguration menu allows the user to set general printer parameters. The test prints the diagnostics form,
which details settings for all functions. The printer partially cuts the paper between each variation.
The printouts might vary. The test ends with a partial cut of the paper. A complete test printout might require the
use of several feet of paper.
You might not need to change the conguration of the printer. If you make adjustments to the conguration, be
careful not to inadvertently change settings that might aect the printer’s performance. HP does not
recommend changing the printer conguration.
NOTE: The printer is shipped with a test printout that includes the preset conguration. Use these settings as a
default to reset the printer, if necessary.
Entering conguration mode
1. Turn o the printer.
2. Be sure that paper is loaded in the printer and the printer cover is closed.
3. Turn the printer on, and press and hold the paper feed button until the conguration printout begins.
The printer beeps and then prints Diagnostics Form I.
4. After this form nishes printing, press the paper feed button within 2 seconds to enter the conguration
main menu.
The printer prints Diagnostics Form II and then the Main Menu.
5. Enter a menu selection using short clicks for no and long clicks for yes. Follow the printed instructions.
● Short click: Press the paper feed button for less than a second.
● Long click: Press the paper feed button for more than a second.
Entering conguration mode 9