Programming Guide - HR2150-HP HP Value Barcode Scanner

232
Factory Defaults Table
Parameter Factory Default Remark
System Settings
Barcode Programming Disabled (Exit Setup)
Programming Barcode Data Do not transmit
Illumination On
Aiming On
Good Read LED On
Good Read LED Duration Short (20ms)
Power On Beep On
Good Read Beep On
Good Read Beep Duration Medium (80ms)
Good Read Beep Frequency Medium (2730Hz)
Good Read Beep Volume Loud
Scan Mode Level Mode
Decode Session Timeout 3,000ms. 1-3,600,000ms; 0: Infinite
Image Stabilization Timeout (Sense Mode) 200ms 0-3,000ms
Timeout between Decodes (Same
Barcode)
Disabled
1,500ms 1-3,600,000ms
Image Decoding Timeout 500ms 1-3,000ms
Sensitivity Medium Sensitivity
Trigger Commands Disabled
Read Barcode On
Decode Area Whole Area Decoding
Specify Decoding Area 40% top, 60% bottom, 40% left, 60% right
Image Flipping Do Not Flip
Smart Stand Mode On
Bad Read Message
Off
NG 1-7 characters
Default Interface USB HID Keyboard
USB Interface
USB Country Keyboard US keyboard USB HID Keyboard
Beep on Unknown Character Off USB HID Keyboard
Emulate ALT+Keypad Off USB HID Keyboard
Code Page Code Page 1252 (West European Latin) USB HID Keyboard