Programming Guide - HR2150-HP HP Value Barcode Scanner

Enter Setup
27 ** Exit Setup
Timeout between Decodes (Same Barcode)
Timeout between Decodes (Same Barcode) can avoid undesired rereading of same barcode in a given period of time. This
feature is only applicable to the Sense and Continuous modes.
To enable/disable the Timeout between Decodes (Same Barcode), scan the appropriate barcode below.
Enable Timeout between Decodes (Same Barcode): Do not allow the scanner to re-read same barcode before the
timeout between decodes (same barcode) expires.
Disable Timeout between Decodes (Same Barcode): Allow the scanner to re-read same barcode.
Enable Timeout between Decodes (Same Barcode)
** Disable Timeout between Decodes (Same Barcode)
The following parameter sets the timeout between decodes for same barcode. It is programmable in 1ms increments from
1ms to 3,600,000ms. When it is set to a value greater than 3,000, the timeout for rereading same programming barcode is
limited to 3,000ms. The default setting is 1,500ms.
Timeout between Decodes (Same Barcode)
Set the timeout between decodes (same barcode) to 1,000ms:
1. Scan the Enter Setup barcode.
2. Scan the Timeout between Decodes (Same Barcode) barcode.
3. Scan the numeric barcodes “1”, “0”, “0” and “0” from the “Digit Barcodes” section in Appendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Exit Setup barcode.