Programming Guide - HR2150-HP HP Value Barcode Scanner

Enter Setup
** Exit Setup 30
Trigger Commands
When Enable Trigger Commands is selected, you can activate and deactivate the scanner in the Level mode with serial
trigger commands. Sending the Start Scanning command (default: <SOH> T <EOT>, user-programmable) to the scanner
in the Level mode activates a decode session. The decode session continues until a barcode is decoded or the decode
session timeout expires or the scanner receives the Stop Scanning command (default: <SOH> P <EOT>, user-
programmable).
** Disable Trigger Commands
Enable Trigger Commands
Modify Start Scanning Command
The Start Scanning command can consist of 1-10 characters (HEX values from 0x01 to 0xFF). In this command, the
character “?” (HEX: 0x3F) cannot be the first character. The default Start Scanning command is <SOH> T <EOT>.
Modify Start Scanning Command
Set the Start Scanning command to “*T”:
1. Scan the Enter Setup barcode.
2. Scan the Modify Start Scanning Command barcode.
3. Scan the numeric barcodes “2”, “A”, “5” and “4” from the “Digit Barcodes” section in Appendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Exit Setup barcode.