Programming Guide - HR2150-HP HP Value Barcode Scanner

Enter Setup
33 ** Exit Setup
Program the scanner to only read Barcode 1 in the figure above by setting the decoding area
to 10% top, 45% bottom, 15% left and 30% right:
1. Scan the Enter Setup barcode.
2. Scan the Top of Decoding Area barcode.
3. Scan the numeric barcode “0” from the “Digit Barcodes” section in Appendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Bottom of Decoding Area barcode.
6. Scan the numeric barcodes “4” and “5” from the “Digit Barcodes” section in Appendix.
7. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
8. Scan the Top of Decoding Area barcode.
9. Scan the numeric barcodes “1” and “0” from the “Digit Barcodes” section in Appendix.
10. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
11. Scan the Left of Decoding Area barcode.
12. Scan the numeric barcode “0” from the “Digit Barcodes” section in Appendix.
13. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
14. Scan the Right of Decoding Area barcode.
15. Scan the numeric barcodes “3” and “0” from the “Digit Barcodes” section in Appendix.
16. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
17. Scan the Left of Decoding Area barcode.
18. Scan the numeric barcodes “1” and “5” from the “Digit Barcodes” section in Appendix.
19. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
20. Scan the Exit Setup barcode.
Barcode 1
Barcode 2