Maintenance and Service Guide

Fingerprint reader board
Table 5-9 Fingerprint reader board description and part number
Description Spare part number
Fingerprint reader board
NOTE: The ngerprint reader board spare part kit does not include the cable. The cable is available as
spare part number L63596-001.
L63595-001
Before removing the ngerprint reader board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 25).
2. Remove the bottom cover (see Bottom cover on page 26).
3. Remove the battery (see Battery on page 28).
4. Remove the card reader/audio board (see Card reader/audio board on page 34).
Remove the ngerprint reader board:
1. Remove the Phillips M2.0 × 2.5 screw (1) that secures the ngerprint reader bracket to the computer.
2. Rotate the bracket upward (2), and then remove the bracket from the computer (3).
3. Disconnect the cable from the ZIF connector on the ngerprint reader board (4), and the remove the
board from the computer (5).
Reverse this procedure to install the ngerprint reader board.
Component replacement procedures 37