Maintenance and Service Guide

Power connector
Table 5-13 Power connector description and part number
Description Spare part number
Power connector 806746-001
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 25).
2. Remove the bottom cover (see Bottom cover on page 26).
3. Remove the battery (see Battery on page 28).
4. Remove the display assembly (see Display assembly on page 43).
Remove the power connector cable:
1. Disconnect the cable from the system board (1).
2. Remove the cable from the routing channel in the left speaker (2), and then remove the cable from the
computer (3).
Reverse this procedure to install the power connector cable.
52 Chapter 5 Removal and replacement procedures for authorized service provider parts