Specifications

10. Remove the base enclosure (see Base enclosure on page 55).
11. Remove the USB board (see
USB board on page 69).
12. Remove the fingerprint reader module (see
Fingerprint reader board on page 71).
Remove the Leap Motion module:
1. Disconnect the Leap Motion module cable (1) from the system board.
2. Remove the two Phillips PM1.5×2.5 screws (2) that secure the Leap Motion module to the top
cover.
3. Detach the Leap Motion module grounding shield (3) from the top cover. (The Leap Motion
grounding shield is attached to the top cover with double-sided adhesive.)
4. Remove the Leap Motion module (4).
Reverse this procedure to install the Leap Motion module.
Power connector cable
Description Spare part number
For use only on computer models equipped with a graphics subsystem with discrete memory 720240-001
For use only on computer models equipped with a graphics subsystem with UMA memory 720241-001
Component replacement procedures 73