HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide

Programming Reference Guide 153
2D SYMBOLOGIES
The reader supports the following 2D symbologies (barcode types). Symbology-dependent options for each
symbology are included in this chapter. See "1D Code Selection" starting on page 61
for configuration of 1D
barcodes.
2D Global Features
The following features are common to all, or in some cases, most of the available 2D symbologies. Default
settings are indicated at each feature/option with a green arrow. Also reference Appendix B, Standard Defaults
for a listing of the most widely used set of standard factory settings. That section also provides space to record
any custom settings needed or implemented for your system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING barcode at the top of applicable programming pages.
2. Scan the correct barcode to set the desired programming feature or parameter. You may need to cover
unused barcodes on the page, and possibly the facing page, to ensure that the reader reads only the bar-
code you intend to scan.
3. If additional input parameters are needed, go to Appendix D, Keypad, and scan the appropriate characters
from the keypad.
Complete the programming sequence by scanning the ENTER/EXIT PROGRAMMING barcode to exit
Programming Mode.
2D Global Features
• 2D Maximum Decoding Time on page 154 • 2D Normal/Inverse Symbol Control on page 155
• 2D Structured Append on page 155
2D Symbologies
• Aztec Code on page 156 • Micro PDF417 on page 171
• China Sensible Code on page 159 • QR Code on page 174
• Data Matrix on page 162 • Micro QR Code on page 177
• Maxicode on page 165 • UCC Composite on page 180
• PDF417 on page 168 • Postal Code Selection on page 182
Additional information about many features can be found in the “References” chapter.
If you make a mistake before the last character, scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the beginning.