HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide

Enter/Exit Programming Mode Micro PDF417
172 Programming Reference Guide
Micro PDF417 Length Control
This feature specifies either variable length decoding or fixed length decoding for this symbology.
Variable Length: For variable length decoding, a minimum and maximum length may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
Micro PDF417 Set Length 1
Specifies one of the barcode lengths for Micro PDF417 Length Control. Length 1 is the minimum label length
if in Vari ab le L en gth Mode, or the first fixed length if in Fixed Length Mode. Length includes the barcode’s
data characters only. Characters can be set from 0001 to 0366 characters (pad with zeroes) in increments of 01.
Any value greater than 0366 will be considered to be 0366.
See page 193 for detailed instructions on setting this feature.
Micro PDF417 Length Control = Variable Length
Micro PDF417 Length Control = Fixed Length
Select Micro PDF417 Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
barcode again.
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
$CMILC00(CR)
$CMILC01(CR)
$CMIL1
~
DEFAULT
0001 = Length 1 is 1 Character